American Audio COMMANDER PLUS - REV 1-2 Guide de l'utilisateur télécharger pdf (Page 15)

UG-196-02-C

196-02-C - DA7322 Audio Codec with DSP

User guide UG-196-02-C

Revision 0.6

15-September-2014

CFR0011-121-00 Rev 1

15 of 21

The control interface has a series of coloured tabs along the top of the interface. These are used to

select a group of registers for different areas of the device. The tabs available along the top of the

interface are Config, Mic Input, HP/Line Output, Out Filter, In Filter, DAI, ACC, Outputs, ALC, Clock

Ctrl, DSP Ctrl and DA7323 as shown in Figure 5.

Each tab can be selected by left clicking on the tab. A register cluster is then displayed below for the

associated tab. These consist of a mixture of Boolean toggle buttons, multi-value ring controls, or

slide controls, as well as a hexadecimal read-back indicators showing the total equivalent register

value and a read-back indicator showing the current register value. The Event Register is labeled

with a register number in decimal and its hexadecimal equivalent.

The read-back indicator readings can be switched individually to decimal, octal, hexadecimal or

binary by clicking on the ‘x’, or they may all be changed at once between hexadecimal and binary

using the ‘Settings>Binary Indicators’ menu item.

Hexadecimal value of

the buttons selected

for the register

Decimal value of

‘x’ - Read-back

indicator selector

Read-back value of register contents

Normally in hexadecimal but can be

changed by clicking on the read-back

indicator selector button

Hexadecimal value of

Tabs to select a

page of registers

relating to the tab

title name

Figure 5: Tabs and read-back indicator

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 21

Pas de commentaire

American Audio COMMANDER PLUS - REV 1-2 Guide de l'utilisateur Page 15