American Audio VMS4 Guide de l'utilisateur télécharger pdf (Page 15)

VirtualDJ 8 – American Audio VMS4

Midilog Routing using the ASIO settings (Windows only)

An alternative (but not suggested) way to assign the Midilogs to a different Output channel

(instead of editing the Audio configuration of VirtualDJ as above) is within the ASIO Settings

utility of the VMS4.

The default Midilog Channel assignment is the following.

Default Midilog Channels 8out mode

Default Midilog Channels 4out mode

The Midilog routing on Mac OSX computers is only available within the Audio configuration

of VirtualDJ.

EQ mode

The Equalizer (Treble, Mid & Bass) section of the VMS4/VMS4.1 can work in two different

modes, Pre EQ and Post EQ and those are offered in both 4out and 8out modes.

How to:

To toggle between the 2 EQ modes, before powering up the VMS4, press and hold the PFL

CUE (4) on the 4th MIDILOG channel and then power "ON" the unit. Release the button.

Your computer may reinstall the VMS4 as a new device, please allow 10-20 seconds for the

change to take place.

You can verify the change from the ASIO Settings Utility (Windows only)

Pre EQ mode (default)

Post EQ mode

In Pre EQ the USB audio signal is affected

by the VMS4 EQ. Pre EQ is the default EQ.

Pre EQ mode the ASIO Driver will list the

VMS4 device number, the first number in

the sequence will be a "0" (see image below)

Post EQ is for users who prefer using the EQ

from VirtualDJ instead of the Hardware one

(e.g. to get the parametric EQ of VirtualDJ

8).

In Post EQ mode the ASIO Driver will list the

VMS4 device number, the first number in

the sequence will be a "1" (see image below)

1 2 ... 10 11 12 13 14 15 16 17 18 19

Pas de commentaire

American Audio VMS4 Guide de l'utilisateur Page 15