American Audio RADIUS 3000 Guide d'installation télécharger pdf (Page 8)

VirtualDJ 8 – American Audio RADIUS 3000

16. PITCH BEND. Press and hold down these buttons to temporary speed up/slow

down the song while pressed. When released, the track playback will return to the

speed designated by the Pitch Fader.

17. PITCH. Adjust the track's playback speed (tempo).

The actual pitch fader will not alter the pitch of the track if the actual pitch and the

software pitch value do not match (software soft-takeover, ghost fader visible on the

GUI). In most cases this may happen if SYNC is prior pressed or switching decks

and the other deck is having a different pitch software value.

B.LOOP

18. IN. Press this button to set a

Loop In (Entry point).

Hold TAP(S) down and then

press this button to set the

Jogwheel to Loop In mode

and (fine) adjust the Loop In

point using the jog (6) when a

loop is enabled. The Led of the

button will blink to indicate the

Loop In Wheel mode. Press

again to return the Jogwheel to

Jog mode.

19. OUT. Press this button to set a Loop Out (Exit point).

Hold TAP(S) down and then press this button to set the Jogwheel to Loop Out

mode and (fine) adjust the Loop Out point using the jog (6) when a loop is enabled.

The Led of the button will blink to indicate the Loop Out Wheel mode. Press again to

return the Jogwheel to Jog mode.

20. RELOOP. Press this button to exit a Loop if enabled or trigger the last used/saved

loop if not (reloop).

Hold TAP(S) down and then press this button down to set the the Jogwheel to Loop

Movemode and (fine) adjust the size of the loop using the jog (6) when a loop is

enabled. The Leds of both the IN (18) and OUT (19) buttons will blink to indicate the

Loop Out Wheel mode. Press again to return the Jogwheel to Jog mode.

21. BEAT <. Press this button to half the size (in beats) of the Loop.

22. BEAT >. Press this button to double the size (in beats) of the Loop.

23. SMART. Use this button to enable/disable the Smart Loop mode. If enabled,

VirtualDJ will automatically adjust the length of the manual loop (using IN and OUT)

to the nearest size in order a seamless (on beat) loop to be offered.

Hold TAP(S) down and then use this button to enable/disable the Loop Roll mode. If

this mode is enabled the led right above this button will blink as an indication and the

IN, OUT and RELOOP buttons will now offer temporary Loop Roll actions.

1 2 3 4 5 6 7 8 9 10 11 12

Pas de commentaire

American Audio RADIUS 3000 Guide d'installation Page 8